Lianzong Second - generation Fire - fighting Water Monitor
(Automatic Tracking and Jet Fire - extinguishing Device)
| Model |
Working Pressure |
Protection Radius |
| ZDMS 0.6/5S |
0.6MPa |
30 meters |
| ZDMS 0.6/10S |
0.6MPa |
35 meters |
 |
1.Thermal imaging + laser - assisted fire source positioning component for precise positioning |
| 2.Aluminum shell, fire - proof and collision - resistant |
| 3.1080P high - definition video camera |
| 4.Red and ultraviolet flame detection component |
Four - in - one Function
| Automatic Alarm |
Fire Source Tracking |
Automatic Fire - extinguishing |
Video Surveillance |
Product Advantages
During the product design and production, dust - proof, waterproof features, and an extended service life are fully considered, which multiplies the overall service life.
- 1.Enclosed gear chamber
- The gear chamber is fully sealed with lubricating oil injection, preventing gear wear and extending the service life.
- 2.Waterproof mainboard box
- Sealed and waterproof - treated to provide dust - proof and waterproof functions.
- A waterproof coating is added to the mainboard to prevent circuit damage in humid environments.
- 3.Electrophoretic coating process
- The body components adopt the electrophoretic coating process, which is mold - proof and corrosion - resistant.
- 4.Heat - shrinkable tubing wire harness
- All wires are wrapped with heat - shrinkable tubing to prevent abrasion and facilitate maintenance.
- 5.Enclosed wire compartment
- Wires are enclosed in the wire compartment, providing dust - proof and waterproof protection.
Precautions
- When installing the fire - fighting water monitor by hoisting, it should be at least 50 cm away from surrounding obstacles, and must not block the 360 - degree rotation of the water monitor.
- There is a "this line towards the wall" mark at the flange of the water monitor, and this mark should face the wall.
- There is an ultraviolet sensor directly below the monitor shell. When installing, handle it with care to avoid damage.
- For the cable that comes with the water monitor, a certain length should be reserved during installation to allow it to rotate freely.
- The Y - type filter should be installed in front of the solenoid valve to filter impurities in the water and prevent the valve from being blocked.
Wiring Instructions
- Connect the four 220V power cables to the corresponding terminals in the order marked as 1, 2, 3, 4. The two CAN signal wires should be wired in a daisy - chain (hand - in - hand, one - in, one - out) manner and pay attention to polarity. Set the terminal resistor to ON. The video cable is point - to - point, and each device should be directly connected to the main unit. If the distance exceeds 300 meters, it is recommended to use optical fiber + optical transceiver.
- For every additional 32 devices, add a loop for the signal wires and power cables, and add a loop board to the main unit.
| Wiring |
View |
Explanation |
Wire Type and Number |
| Power Cable |
|
2 red (live wires), 1 blue (neutral wire), 1 yellow (ground wire) |
NH - BV - 4*2.5 |
| Power Cable |
|
1 red (live wire), 1 blue (neutral wire) |
NH - BV - 2*2.5 |
| Valve Power Cable |
|
1 red (live wire), 1 blue (neutral wire) |
NH - RVS - 2*1.5 |
| Water Monitor Signal Cable |
|
2 wires |
NH - RVS - 2*1.5 |
| Video Cable |
|
1 coaxial cable |
NH - SYV75 - 5 |
| Pump - Starting Cable |
|
4 wires |
NH - RVS - 4*1.5 |
){kind=link}